pv magazine test: November 2022 Results
By George Touloupas
This article was originally published in pv magazine – January 2023 edition. Learn more about the pv magazine test here.
CEA’s Senior Director of Technology & Quality, George Touloupas, provides analysis of the November 2022 energy yield results from the outdoor test field in Xi’an, China.
The first chart below (Figure 1) shows the meteo station data (irradiance and ambient temperature) for November 2022.
Figure 1: Daily temperature and irradiance data - November 2022
Figures 2 and 3 below show the relative specific energy yield comparison between different PV module technologies. Although the top performer is Longi’s bifacial PERC module, the average specific energy yield of the bifacial TOPCon category leads over the average specific energy yield of modules in the bifacial PERC category.
Figure 2: Relative yield of different technologies - November 2022
Figure 3: Total energy yield - November 2022
Our test field currently only has one sample from Jolywood in the n-TOPCon bifacial category. As TOPCon modules become more prominent, we look forward to installing more samples of this type to achieve a more representative yield comparison.
The average bifacial boost is 5.42% for November. Bifacial boost is defined as the relative advantage of the average specific energy yield of all bifacial products compared to the average specific energy yield of all mono-facial mono PERC products.
Table 1: Bifacial boost - August to November 2022
Notes on the energy yield measurements:
The energy yield comparison among various technologies, including bifacial boost, will be analyzed using products installed after the beginning of 2019.
The energy yield is given in Wh/Wp and calculated by dividing the energy produced by the module by the Pmax at STC of the module. This Pmax is the maximum STC power after a process of stabilization.
The results are grouped in categories, per module type.
The bifacial boost depends on many parameters: the bifaciality factor, the installation geometry, the albedo of the ground, and the sun angle and diffuse irradiance. The ground in this case is gray gravel.
Table 2: Energy yield ranking - historical - August to November 2022
Test Cooperation
pv magazine test is a cooperative effort involving pv magazine, APsystems, CEA, and Gsolar. All testing procedures are carried out at Gsolar’s test laboratory in Xi’an, China. CEA supervises these tests and designed both the indoor and outdoor testing procedures.
